3D Design
Community
Discussion
|
Artifice 3D Design Community Discussion |
|
Posted by Peter Bacot on October 29, 1998 at 14:18:48:
In Reply to: Macros. Help! posted by David W. Truswell on October 29, 1998 at 13:03:49:
You cannot edit the existing macros because they are compiled. I wrote a simple macro based on the "write list" function. whereby I could input cartesian points from a surveyor.
Since then I have heard mention that the macro language is no lnoger supported, but the macros are still there so I don't know what this means. I have older manuals with complete macro instructions.. somewhere areound here...
Probably one of the best experts on this is Alfred Scott. contact him at AlfredS@aol.com.
With WildTools I don't know what you might want to write further, but would like to see what you come up with.
Visit the PowerCADD discussion at AOL keywork PowerCADD Good luck.
Peter.