Artifice 
  3D Design 
  Community 
  Discussion

Message - Hipped Roofs

    Follow Ups | Post Followup | Artifice 3D Board | Great Buildings Board        

Posted by  Anne Crowley on November 18, 1998 at 12:41:15:

I'm trying to make a hipped roof from one block, without cutting it. I've found that if I make a gable roof, then I can grab the mid-point handles at the bottom of the block to pull out the ends to make the remaining two sloping sides. But I'd like to shape the remaining two sloping side by dragging the handles at the TOP of the block in to the peak. Since these handles are corner handles, how do I move them to form the slopes? (I'd like to do it the second way since the bottom of the roof is usually set first, based on the wall locations below...)


Follow Up Messages:




Post a Follow Up Message -


Please post continuing discussion to the New Open 3D Forum.

To join in and post to the new DesignCommunity forums:

    1) Go to our new forums area.
    2) Register with your valid email address.
    3) Receive and respond to the confirmation email.
    4) Then login with us, in the new forum system!



 

Follow Up Messages | Post a Follow Up | Artifice 3D Board | User Gallery | Great Buildings Board | Scrapbook
 
Artifice, Inc. ...the way of architecture.

Artifice | CAD Outpost | DesignWorkshop | Great Buildings | RenderCity | Free 3D | Gallery | Support | Search | Index
This document is provided for on-line viewing only.

http://www.designcommunity.com/messages/1230.html