Artifice Design Community Message Board


Message - Re: Translating to/from Form Z


    Follow Ups | Post Followup | Artifice Message Board    

Posted by  kenkuhlman on December 04, 1998 at 16:03:58:

In Reply to:  Translating to/from Form Z posted by Anne Crowley on December 04, 1998 at 13:53:04:

I had the same problem. I think it had to do with openings created in DW and how form-Z reads them. I tested form-Z and did not care for it. Count the number of clicks it takes to move, resize or reshape a box in form-Z compared to DW. Yikes! Try resizing a box in form-Z numerically Double Yikes!!
Ken


Follow Up Messages:






Post a Follow Up Message -


Please post continuing discussion to the New Open 3D Forum.

To join in and post to the new DesignCommunity forums:

    1) Go to our new forums area.
    2) Register with your valid email address.
    3) Receive and respond to the confirmation email.
    4) Then login with us, in the new forum system!



 


Follow Ups | Post Followup | Artifice Message Board



Artifice Foyer | DesignWorkshop | Great Buildings | CAD Store | Free 3D | Gallery | Technical Support | Search | Index
This document is provided for on-line viewing only.

http://www.designcommunity.com/messages/1315.html