Artifice 
  Design 
  Community 
  Discussion 
 		 
 
 

Message - Re: fitting upwards on a "triangular" roof

    Follow Ups | Post Followup | Artifice Message Board        

Posted by  Bob Sprague on December 20, 1998 at 23:08:05:

In Reply to:  fitting upwards on a "triangular" roof posted by Santiago Molina on December 20, 1998 at 20:12:13:

The trim tool works very accurately— just remember to have the snap to grid turned off. Then you can can right on the money

Follow Up Messages:



Post a Follow Up Message -

Please post continuing discussion to the New Open 3D Forum.

To join in and post to the new DesignCommunity forums:

    1) Go to our new forums area.
    2) Register with your valid email address.
    3) Receive and respond to the confirmation email.
    4) Then login with us, in the new forum system!


 

Follow Up Messages | Post a Follow Up | Artifice Message Board
 

Artifice Foyer | DesignWorkshop | Great Buildings | CAD Store | Free 3D | Gallery | Support | Search | Index
This document is provided for on-line viewing only. http://www.designcommunity.com/messages/1394.html