Posted by CJ Shumate on December 28, 1998 at 10:13:54:
In Reply to: Re: fitting upwards on a "triangular" roof posted by Jacques Pochoy on December 21, 1998 at 01:18:40:
Hello Jacques,
There is a way to add vertices to objects in DesignWorkshop! It just involves trimming the object because, afterall, if you trim off a corner you get two sets of vertices where you used to have just one.
So, to add vertices, trim off a small corner of the object. You can throw away the resulting triangular piece, then use the Reshape tool to move the vertices into position.
Occaisionally, you may need to pull the corner out from the object before you have enough of a corner to cut off.
As always, we hope this helps further your understanding of DesignWorkshop.
Happy Holidays,
CJ Shumate
support@artifice.com