Artifice 
  Design 
  Community 
  Discussion 
   
 

Message - Re: Square vs. Round

    Follow Ups | Post Followup | Artifice Message Board        

Posted by  Bob Bissett on February 21, 1999 at 13:09:05:

In Reply to:  Re: Question on V2.0 Revisted posted by Kevin Matthews on February 20, 1999 at 15:36:46:

I didn't mean to seem disloyal to DW. I like it very much and have gotten some very nice results with it. I have a special problem with mostly domes to design. I need to make openings other than simple flat-wall doors and windows. Using the cutting tool is just too slow and too inaccurate. I can stick doors and windows on the surface of the dome, but I also need to make larger curvilinear openings for which only Booleans are practical. That is why I am still looking for another program.

If I did nice square buildings with nice flat planes DW would be very hard to beat for ease of use and quality of end product.

This is my problem. I'll have to keep looking till I find an acceptible solution. For most designers DW would be fine.

Bob...  


Follow Up Messages:




Post a Follow Up Message -


Please post continuing discussion to the New Open 3D Forum.

To join in and post to the new DesignCommunity forums:

    1) Go to our new forums area.
    2) Register with your valid email address.
    3) Receive and respond to the confirmation email.
    4) Then login with us, in the new forum system!



 

Follow Up Messages | Post a Follow Up | Artifice Message Board
 
Artifice, Inc. ...the way of architecture.

Artifice | CAD Outpost | DesignWorkshop | Great Buildings | RenderCity | Free 3D | Gallery | Support | Search | Index
This document is provided for on-line viewing only. http://www.designcommunity.com/messages/1749.html