Design 
  Community 
  Open 3D 
  Discussion
 

Message - Re: Creating a helix

Follow Ups | Open 3D Forum | DesignWorkshop Forum | Architecture Forum
   

Posted by  ankita jariwala on January 17, 2004 at 21:58:22:

In Reply to:  Re: Creating a helix posted by Mike on January 15, 2004 at 07:07:13:

hi,
for creating solid spiral u have to use sweep in SOLIDWORKS.

create the helical curve first.
then creat the section for the spring at the start point of the spiral and make this section coincident with the start point for the spiral.
and then use the sweep command.
i think this will solve ur problem.
bye
good luck

 
ArchitectureWeek   Digital Design Tools Department   Architecture Search  


Post a Follow Up Message -

Subject:       


Please post continuing discussion to the New Open 3D Forum.

To join in and post to the new DesignCommunity forums:

    1) Go to our new forums area.
    2) Register with your valid email address.
    3) Receive and respond to the confirmation email.
    4) Then login with us, in the new forum system!


Open 3D Forum | DesignWorkshop 3D Forum | User Gallery | Architecture Forum | Scrapbook | ArchitectureWeek
 

Special thanks to our Sustaining Subscribers including BuilderSpace.com .

Home | CAD Outpost | DesignWorkshop | Great Buildings | RenderCity | Free 3D | Gallery | Search | ArchitectureWeek
This document is provided for on-line viewing only. http://www.DesignCommunity.com/messages/21587.html