Posted by Bob Sprague on August 17, 1999 at 19:20:44:
In Reply to: Re: Posted on the PowerCadd Board too.... posted by gary veasy on August 17, 1999 at 08:45:09:
Yes, joined lines defining a shape in PCADD DO import as a polyline object (in plan) ready to extrude, rotate to a vertical position and then cut holes in it!
On very complex curves, you do have to watch that you don't get more than one point at a vertex (except at starting point). You can check this in PCAD with 2nd click on "RESHAPE" to see a count of points and where the starting/end points are!
DW Tech has update its tools so that the superimposition of start/end points does not result in a "vertec error".