Posted by  Bill on March 12, 2004 at 08:09:17:

In Reply to:  Re: PowerCADD and SketchUp posted by Rob Coolidge on March 11, 2004 at 21:09:02:

Rob,

For what it is worth the PC DWG Translator does support polygons going both ways. Polygons are called polylines in acad. Assuming SkUp has a polygon primitive it would seem that sending one simple polygon would end up as a polygon when it was received. Could you verify?

Thanks.

Bill Stanley

Responses:

• Re: PowerCADD and SketchUp Robert Sandkam 10:10:43 3/12/2004 (9)
  • Re: PowerCADD and SketchUp Bill 08:15:12 3/15/2004 (2)
    • Re: PowerCADD and SketchUp Rob Coolidge 19:50:48 3/15/2004 (1)
      • Re: PowerCADD and SketchUp Bill 21:31:28 3/15/2004 (0)
  • Re: PowerCADD and SketchUp Rob Coolidge 18:35:12 3/13/2004 (5)
    • Re: PowerCADD and SketchUp fjjRA 06:36:45 3/15/2004 (4)
      • Re: PowerCADD and SketchUp Rob Coolidge 19:56:29 3/15/2004 (3)
        • Re: PowerCADD and SketchUp fjjRA 06:07:51 3/16/2004 (2)
          • Re: PowerCADD and SketchUp Rob Coolidge 09:16:03 3/16/2004 (1)
            • Re: PowerCADD and SketchUp fjjRA 12:08:56 3/16/2004 (0)

Post a Response -