Re: PowerCADD and SketchUp - PowerCADD Forum

Posted by Robert Sandkam on March 12, 2004 at 10:10:43:
In Reply to: Re: PowerCADD and SketchUp posted by Bill on March 12, 2004 at 08:09:17:
SketchUp doesn't seem to support polygons/polylines.
Even when you use the rectangle tool in SketchUp, the end result is four lines.
It is just the way that SketchUp works.
b0b.

http://www.graphisoft.com/products/virtual_building/

PowerCADD Forum sponsored by DesignWorkshop® Professional · Search

Responses:

Re: PowerCADD and SketchUp Bill 08:15:12 3/15/2004 (2)
- Re: PowerCADD and SketchUp Rob Coolidge 19:50:48 3/15/2004 (1)
  - Re: PowerCADD and SketchUp Bill 21:31:28 3/15/2004 (0)
Re: PowerCADD and SketchUp Rob Coolidge 18:35:12 3/13/2004 (5)
- Re: PowerCADD and SketchUp fjjRA 06:36:45 3/15/2004 (4)
  - Re: PowerCADD and SketchUp Rob Coolidge 19:56:29 3/15/2004 (3)
    - Re: PowerCADD and SketchUp fjjRA 06:07:51 3/16/2004 (2)
      - Re: PowerCADD and SketchUp Rob Coolidge 09:16:03 3/16/2004 (1)
        
        Re: PowerCADD and SketchUp fjjRA 12:08:56 3/16/2004 (0)

Post a Response -

Subject:

Please post continuing discussions to the new DesignCommunity Forums.
To post successfully to the new membership-based DesignCommunity Forums:
1) Go to the new forums area.
2) Register with a valid email address.
3) Receive and respond to the confirmation email.
4) Then login to the new forum system.

Design Community PowerCADD Discussion
Message - Re: PowerCADD and SketchUp
Respond \| PowerCADD Forum \| DesignWorkshop Forum \| Home \| Search